Kyvol Cybovac L20 Brush Roller Motor Replacement

ID: 171854

Description: If your Kyvol Cybovac L20 is struggling to...

Steps:

1. Begin with the device laying on a flat surface with the power button facing up.

2. Remove both of the side brushes.

3. Use a Phillips #1 screwdriver to remove two 1 mm screws that secure the panel.
4. Remove the battery panel.

5. Slightly lift the battery out of the compartment.
6. Disconnect the battery connector.
7. Completely remove the battery.

8. Remove the dust bin from the underside of the unit.

9. Press in on the two clips holding the brush roller housing in place and remove the brush roller cover.

10. Remove the brush roller.

11. Remove the eight 12 mm Phillips screws from the underside of the unit.

12. Slightly lift the bottom of the unit from the top housing, with care not to pull or damage the connections between the top case and motherboard.
13. Disconnect the three motherboard connections that connect the top case and motherboard.

14. Remove the two 5.8 mm Phillips screws holding dustpan sensor board in place.
15. Move the sensor to the side.

16. Remove the three 8 mm Phillips screws that secure the motor housing in place.

17. Remove the two 7.4 mm Phillips screws from the belt assembly housing cover.
18. Remove the cover.

19. Slip off the belt and pulley from the inside of the motor housing.

20. Remove the two 4.5 mm Phillips screws that secure the motor to the pully assembly housing.
21. Separate the motor from the housing.

22. Grip the white motor motherboard connect and pull it directly up and out of its port.
23. Remove the motor.