Marshall Stanmore II Tweeter Assembly Replacement

ID: 171964

Description: This guide is to be used for the replacement of...

Steps:

1. Turn off the device and unplug the cable from the wall and the speaker.
2. Lay the speaker with the back panel facing up on a flat, stable work surface.

3. Use a Phillips #2 screwdriver to remove the ten 20.5 mm screws that secure the rear panel to the chassis.

4. Carefully lift the rear panel and let it rest on an object, like a stack of books, to avoid straining the cables.
5. Do not attempt to fully remove the panel, as this will damage the connections inside.

6. Carefully pull back the translucent plastic sheathing on the two silver tweeter connectors.

7. Using your fingernail or tweezers, apply precise pressure to the small latch in the middle of the connector and gently pull upwards to disconnect the connector.
8. Repeat for the second connector.

9. Use a Torx T20 screwdriver to remove the three 20.5 mm screws that secure the tweeter.
10. Lift the tweeter assembly from its housing.

11. The felt seal is removable. If there is no seal on the tweeter, it may be stuck to the cutout on the speaker frame.
12. Repeat steps 4-6 to remove the second tweeter if necessary.