Roconia Q6 OK Button Replacement

ID: 172012

Description: This manual provides instructions for changing...

Steps:

1. Flip your device upside down so that the interface is facing downwards.

2. The device is supported by rubber pieces located at the bottom extremities.
3. There are screws beneath the rubber pieces that can be removed. Remove all four 1.1 mm Phillips #1 screws by using the Phillips #0 screwdriver.

4. Turn device over again and pry open the device to remove the cover.

5. Pull out the cable that is connected to the top cover to fully separate.

6. Use a Phillips #0 screwdriver to remove each of the 5.2 mm screws from the sensor board inside the cover.

7. Remove the motherboard and you will see the the pieces that help control the buttons.
8. Locate where the OK button is placed.
9. Remove the part that helps control the OK button by pulling it out