KitchenAid KSM150PSER Circuit Board Replacement

ID: 103195

Description: The circuit board is a small part inside the...

Steps:

  1. Using a Phillips #2 screwdriver, remove the 10mm screw on the back cover by rotating it counterclockwise.
  2. The back cover is now free. Remove it by pulling it back and up.
  3. Ensure that the mixer is disconnected from any electrical source prior to removing the back cover.
    4. Step image Step image
  4. Using a Phillips #1 screwdriver, remove the 9.5mm screw above the circuit board by rotating it counterclockwise.
  5. If you can't see the screw, try pulling the seal down past the wires to make the screw more accessible.
    6. Step image Step image
  6. Using pliers or tweezers, remove the connectors of the four wires attached to the circuit board.
    7. Step image Step image
  7. Grab the wires and tilt the edge of the board up to lift the circuit board up and out.
    8. Step image
Back