HP Officejet Pro 6835 Speaker Replacement

ID: 103339

Description: After consistent use the printer speaker can...

Steps:

  1. Open the main lid as far as it will go.
  2. Use a plastic opening tool to gently pry off the hinge on the right side by pushing it to the left and off the hook.
  3. Open the lid further.
    4. Step image
  4. Use a T9 torx screwdriver to remove a total of ten (10) 12mm screws from the main cover by turning the screwdriver counterclockwise.
  5. The two screws above the screen assembly are deep so you may need a long screwdriver.
    6. Step image Step image Step image
  6. Grab the main cover and lift it up slightly.
  7. Do not pull too hard—there is a cable connecting the cover to the printer.
    8. Step image
  8. Grab the base of the white ribbon cable connecting the cover to the base of the printer and pull it out.
    9. Step image Step image
  9. Grab the intertwined red and black wires. Gently pull up and disconnect the wires from the motherboard.
  10. Be careful to remove the wires from the socket, NOT the socket from the board.
    11. Step image Step image Step image
  11. Carefully slide the speaker out of the printer.
    12. Step image
Back