Google Pixelbook Right Charging Port Replacement

ID: 103394

Description: In this guide, you will learn how to replace...

Steps:

1. Use the iFixit opening tools or a metal spudger to pry the rubber covers off the back of your Pixelbook.
2. Peel the linings off completely until the back of the Pixelbook looks bare.

3. Remove the two yellow 2.0mm screws by using a T3 Torx screwdriver.

4. Remove the seventeen 3.0mm T5 Torx screws from the bottom panel.

5. Use the nylon spudger to pry the edge of the Pixelbook up until you can grab the edge with your fingers.
6. Open the back panel completely and lay it flat so you see the whole inside of the computer.

7. Remove the yellow 2.0mm screw from the middle of the panel by using the T3 Torx screwdriver to turn the screw counterclockwise.

8. Remove the small, black casing by using the spudger to lift it up from its place.

9. Disconnect the flat, black cord from the main component by using a spudger to push it out of the slot, or by using your hand to carefully pull it out.
10. Your back panel is now free from the main component.

11. Remove the three 2.0mm black screws from the sound card by using a T5 Torx screwdriver to turn them counterclockwise.
12. Remove the gold 3.0mm screw by using a T3 Torx screwdriver to turn it counterclockwise.

13. Disconect the thin, black and red cord from the motherboard by using the spudger to snap the connector up and out of place.

14. Remove the yellow 2.0mm screw by using the T3 Torx screwdriver to turn the screw counterclockwise.

15. Remove the small, red component by lifting it up with the spudger.

16. Disconnect the metal component of the thin, black component by lifting it up with the spudger.

17. Remove the right charging port by picking it up with the tweezers and lifting it from the computer.