Canon PowerShot SD1400 IS User Interface Panel Replacement

ID: 105132

Description: The buttons on the user interface panel can...

Steps:

  1. Remove the four 2.0 mm Phillips screws of the camera using the J00 bit from the 54-bit Driver Kit. There are two screws on both sides.
    2. Step image Step image Step image
  2. Remove the 4.0 mm Phillips screw located on the bottom of the camera.
    3. Step image
  3. Remove the front face panel of the camera by hand using firm pressure.
  4. If one point of the face is stuck to the body, check if there is a screw preventing the front face from coming off.
    5. Step image
  5. Remove the rear panel of the camera by hand using firm pressure.
    6. Step image
  6. Remove the user interface panel by hand. The panel may fall out on its own, this is normal.
  7. Replace the user interface panel by setting it in position.
    8. Step image
Back