Protocol Galileo Stealth Pinion Gear Replacement

ID: 105373

Description: This guide will walk you through how to remove...

Steps:

1. Remove the chrome shaft cover by lightly pulling it away from the drone.

2. Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.
3. Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

4. Remove the propeller stop from shaft by lightly pulling it away from the drone.

5. Remove the propeller from shaft by lightly pulling it away from the drone.

6. Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.
7. Take care to place the screws in a safe place to prevent losing them.

8. Separate the upper and lower housing units by lightly pulling the two housing units apart.

9. Lift the pinion gear off the motor shaft by lightly pulling it away from the drone.