Dell Precision 5520 Memory Module Replacement

ID: 108345

Description:

Steps:

  1. Be sure to power off and unplug your device before you begin your repair.
  2. Turn the system badge flap over (1) and then remove the ten M2x3 screws that secure the base cover to the computer (2).
  3. Pry the edges of the base cover and lift it to remove it from the computer.
  4. NOTE: Use a Torx #5 screwdriver for the base screws and a Phillips screwdriver for the two M2x8 screws inside the badge flap.
    5. Step image Step image
  5. Disconnect the battery cable from the system board [1].
  6. Remove the seven M2x4 screws that secure the battery to the computer [2].
  7. Lift the battery off the computer [3].
  8. Do not apply pressure to the surface of the battery
  9. Do not bend
  10. Do not use tools of any kind to pry on or against the battery
  11. If a battery cannot be removed within the constraints above, please contact Dell technical support
    12. Step image
  12. Pry the securing clips away from the memory module until it pops-up [1]. Then, remove the memory module from its connector on the system board [2].
    13. Step image
Back