Samsung Radiant360 R3 Wireless Setup Button and USB Module Replacement

ID: 108513

Description: In this guide, we will be replacing the USB...

Steps:

  1. Flip the device so that the bottom of the device is facing you. Remove these feet with a pair of tweezers.
  2. Remove the four 10mm long screws with the Phillips #1 screwdriver.
    3. Step image Step image Step image
  3. Remove the bottom shell from the speaker.
    4. Step image
  4. Remove the connector from the board by pressing down on the center tab while nudging the connector away with a spudger.
  5. Be careful not to pull directly on the wires or apply too much pressure, or you risk breaking the connector.
    6. Step image Step image
  6. Remove the two 10mm long screws from the board utilizing the Phillips #1 screwdriver.
    7. Step image
  7. Use a spudger to press the plastic tab away from the board until the board pops up.
  8. Remove the board with the USB module from the device.
    9. Step image
Back