TiVo Bolt Hard Drive Replacement

ID: 113140

Description: There are currently two methods being used to...

Steps:

1. This screw is a different length than all the other screws.

2. Undo the clips to lift up the Cable card slot cover

3. Do not attempt to remove the housing yet. Still 3 more screws and plastic clips holding it in place

4. This shows the placement of the clips so you know where to place your plastic pics.
5. Make sure to left this cover straight up when removing as you can see on the left side it has prongs that slide into the other part of the plastic housing.

6. Case is still clipped in so do not attempt to remove the case yet

7. Plastic Pic placement shows where the clips are.
8. I found it easy to use a 5th pic on the right to help separate the housing from the board

9. Once you undo this screw you can unplug the harddrive and left up the HDD to separate the HDD and tray from the Board
10. Then undo the screws holding the tray to the HDD. Put the Tray on you new HDD and screw it in.

11. Afterwards I decided to go ahead and add the plastic routing clips on, which are not shown in the picture.