DigiTech RP70 Input/Output ¼” Ports Replacement

ID: 113754

Description: If the input/output port is broken this guide...

Steps:

1. Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
2. Remove the four 8mm Phillips #0 screws located on the back panel.

3. Remove the back panel to expose the motherboard.

4. Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

5. Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

6. Desolder the back of the motherboard where the damaged input/output port is located.