DigiTech RP70 Amp/Mixer Switch Replacement

ID: 113755

Description: If the amp/mixer switch is broken this guide...

Steps:

  1. Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
  2. Remove the four 8mm Phillips #0 screws located on the back panel.
    3. Step image Step image
  3. Remove the back panel to expose the motherboard.
    4. Step image Step image
  4. Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
    5. Step image
  5. Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
    6. Step image
  6. Desolder the back of the motherboard where you want to replace the switch.
    7. Step image
Back