DigiTech RP70 DC Power Connector Replacement

ID: 113852

Description: If the DC power connector is broken this guide...

Steps:

  1. Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
  2. Remove the four 8mm Phillips #0 screws located on the back panel.
    3. Step image Step image
  3. Remove the back panel to expose the motherboard.
    4. Step image Step image
  4. Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
    5. Step image
  5. Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
    6. Step image
  6. Desolder the back of the motherboard where the power connector is located.
    7. Step image
Back