HP Deskjet 1055 Power and Various Buttons Replacement

ID: 11492

Description: This guide provides step-by-step instructions...

Steps:

1. Press your thumb firmly on the center of the button plate on the left side of the printer.
2. Hook your fingers under the front edge of the button plate and pull upward while maintaining pressure in the center with your thumb.
3. To avoid breaking the rear tab, keep your thumb pressed firmly on the plate and lift the front edge carefully as you pull up.

4. Once the front of the plate is loose, lift it up a few inches making sure to hold the back (paper feeding side) of the plate down.
5. Slide the plate towards the back of the printer and then lift up on the back of the plate.
6. The plate should now be disconnected from the tabs on the printer.

7. Flip the plate over to reveal the white ribbon cable that connects it to the printer.
8. Hold the ribbon cable near the connection point and gently pull it straight out from the circuit board to avoid damage.

9. Place the cover down on a flat surface with the button circuit board facing up.
10. Remove the three T-10 Torx screws from the circuit board.

11. Lift the button circuit board up from the plastic cover to remove it.