Dyson DC14 Power Cord Replacement

ID: 11500

Description: This guide will show you the steps necessary to...

Steps:

1. Start with your Dyson DC14 unplugged, standing upright and facing towards you.
2. Remove the canister from the vacuum.
3. Disconnect the telescopic vacuum wand.
4. Remove the two T15 Torx screws securing the switch cover to the vacuum.

5. Push outward on the two plastic clips that secure the switch cover to the vacuum.

6. Remove the switch cover from the vacuum.
7. The purple switch button may separate from the rest of the switch cover.

8. Holding them by their white plastic coverings, firmly pull the two wires from the power switch.
9. Be sure to grip the wires from their attached connectors. Pulling directly on the wires could damage your vacuum.
10. The terminals will only fit one way during reassembly. Only one of the wires is long enough to reach the far terminal of the switch.

11. Remove the other terminal for the power cord that connects to the terminal below the power switch.
12. Holding them by their connectors, separate the remaining wire of the power cord from the internal power cable.