Nokia Lumia 925 Battery Replacement
ID: 115688
Description:
Steps:
- Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.
- Pull out the holder until it is completely separate.
- Something like a paperclip will work if there are no tweezers available.
- Slide a plastic opening tool under the back cover.
- Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.
- Some pins are facing the opposite way from the others.
- Remove the 3 screws using the T7 Torx screwdriver.
- Unclip the black tab connector.
- Remove the silver metal cover.
- Be careful of the tape under the right square side of the panel. Using a spudger helps.
- Unclip the two orange tabs.
- Remove the four silver screws using the T5 Torx screwdriver.
- Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.
- Push the screen from the inside of the phone.
- Pull the screen off.
- Slide the electronic strip through the small opening.
- Locate the grey speaker/camera cover.
- Carefully remove the cover with either a pair of tweezers or your fingers.
- With a pair of tweezers, gently remove the orange colored tab closest to the speaker.
- Pull at the orange section until it becomes loose.
- It is located in the upper leftmost section of the phone behind the front camera.
- Pull vertically on the same orange section until the front camera comes out.
- The front camera as well as the speaker may come out after the last step so be careful.
- Remove the two black screws by using the T5 Torx screwdriver.
- Carefully pull the metal rod out.
- Pry off the speaker.
- Apply heavy pressure, and pull towards the battery.
- Unclip the black wire.
- Peel off the electronic strip.
- Be careful not to tear.
- Pry off the metal vibrating unit using tweezers.
- This requires a lot of force.
- Insert the tweezers under the corner of the battery, and lift out.
- You have successfully removed the battery.
