MSI GP60 2PE Leopard Wireless Card Replacement

ID: 115709

Description: Is your wireless card not working? Here's a...

Steps:

1. Flip MSI GP60 2PE Leopard, so that the back is facing up.

2. Find the unlock tab located on the upper right side of the device, then slide it to the right.

3. Slide and hold the release tab on the left side of the battery, so that you can remove the battery.

4. While holding the release tab, remove the battery slowly.

5. Flip the device over so the back is facing up.

6. Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.
7. There is a screw located under the battery; lift the battery up to access it.

8. Once all four screws are removed, lift the back off.

9. Locate the wireless card.

10. Using a Phillips #00 screwdriver, remove the one 2 mm screw that is holding the wireless card in place.

11. Carefully remove the wireless card.
12. Pay close attention to the two wires attached to wireless card.

13. Remove the wires connecting to the wireless card by pinching around the base where they connect, then carefully disconnect them.
14. The wires should come off fairly easily.
15. Avoid yanking or pulling too hard. This can result in the wires breaking.