Samsung Galaxy Core Prime Screen Replacement

ID: 115710

Description: This guide will enable you to replace the...

Steps:

1. Turn the smartphone off by using the power button on the right-hand side.

2. Turn the smartphone over so that the rear camera is face up.

3. Use your fingernail or a flat tool to lift the back cover.

4. Locate the battery near the bottom of the phone. The battery is square, flat, and is labeled 'SAMSUNG'.

5. Use your fingernail or a flat tool to lift the battery out.

6. Use the Phillips #00 screwdriver to remove the eight 4 mm screws from the midframe.

7. Use a heat gun or hair dryer to loosen the adhesive between the midframe and the rest of the device.
8. Take care when using these heat tools.

9. Use the iFixit Opening Tool to lift the frame.

10. Use tweezers to disconnect the power ribbon from the motherboard.

11. Use tweezers or your hand to remove the audiojack.

12. Use the iFixit Opening Tool to remove the mother board.

13. Lift the plastic panel that separates the digitizer and the motherboard with an iFixit Opening Tool

14. Use a heat gun and an iFixit Opening Tool tool to separate the screen from the digitizer.

15. Use tweezers to disconnect the digitizer.