DeLonghi Nespresso seal capsule cage replacement

ID: 118589

Description:

Steps:

1. Use the OVAL bit to loosen the 4 marked screws.
2. Pry up the side panels.

3. Remove 2 screws (one on each side) with a Torx T10 bit.

4. Use a spudger to pry left and right behind the coffee spout.
5. Additional prying at the bottom left of the clip may be helpful.
6. Take out the coffee dispenser by tilting it forwards.

7. Remove the front panel.

8. The seal of the capsule cage is inside the metal ring.
9. Push the metal ring forward with a spatula, use pliers if necessary.
10. The metal ring and seal will then fall downwards.
11. If necessary, remove the 4 screws with a T10 Torx driver, which will allow to also have access from below which you need to have anyway during reassembly.

12. Replace the defective gasket with a new one and reinstall it along with the metal ring.