Fujitsu Lifebook Stylistic Q584 Motherboard Replacement

ID: 122126

Description: This guide will allow you to replace the...

Steps:

1. Remove the white sticker covering the screws (if applicable).
2. Use the PH1 screwdriver to remove the four 2 mm screws from the the backside of the device.

3. Insert the plastic opening tool along the seam of the back case.
4. Gently slide the plastic opening tool along the entire seam popping the clips free.

5. Carefully lift the back case and remove the smartcard ribbon from the motherboard.

6. Remove the ten 3mm screws with a PH00 screwdriver from the shield.

7. Remove the grey docking station port cover.

8. Gently slide the plastic opening tool along the entire seam popping the clips free.

9. Lift the shield away from the device and remove the fingerprint scanner's ribbon from the motherboard.

10. Pull up the cord that connects the battery to the motherboard

11. Remove seven 1mm screws using a PH00 screwdriver.

12. Disconnect upper peripheral ribbons from motherboard.
13. Disconnect left peripheral ribbon from motherboard.

14. Gently lift the battery from the casing.

15. Remove three 3mm screws using a PH00 screwdriver.

16. Remove all of the ribbon connector cables from the motherboard using an ESD-safe spudger.

17. Gently pry up the motherboard.

18. Gently lift the foil tape under the motherboard to reveal the connector.

19. Remove the clip holding in the connector with an ESD-safe spudger.

20. Remove the connector with an ESD-safe spudger.