HP Split x2 13-g210dx Docking Port Replacement

ID: 122186

Description: If the keyboard does not function when...

Steps:

  1. Carefully peel off the felt cover that is found beneath the display along the bottom of the device.
  2. Use a spudger to gently scrape away the padding that hides the screws in each of the four locations.
  3. Remove the four 4-mm Phillips #0 screws.
  4. Run a spudger along the crease of the entire laptop and slowly pry off the back panel of the device, beginning with the bottom edge.
  5. You will hear popping noises as the clips separate from each other.
    6. Step image
  6. Remove the three 6-mm Phillips #0 screws.
  7. Remove the four 4-mm Phillips #0 screws.
    8. Step image
  8. Remove the white connector clip from the connector port using a sturdy tweezers.
    9. Step image Step image
  9. Lift the battery away from the device.
    10. Step image Step image
  10. Remove the two 4-mm Phillips #0 screws.
    11. Step image
  11. Remove the clips from the docking port board with a sturdy pair of tweezers.
    12. Step image Step image
  12. Remove the two ribbons labeled "Dock" at the top of the docking port board using tweezers or a sturdy plastic opening tool.
    13. Step image Step image
  13. Lift the docking port away from the device.
    14. Step image
Back