Opening the Jura Z series housing

ID: 124870

Description: For most repairs, the case of the Jura Z must...

Steps:

  1. Unplug the machine from the power outlet
  2. Remove all attachments: water tank, drip tray, aroma lid
    3. Step image
  3. Turn the machine so the back is facing toward the front.
  4. The Jura sign must be removed. Turn it a few millimeters counterclickwise.
  5. If this becomes difficult use a suction cup to assist.
  6. Remove the Jura sign.
    7. Step image Step image Step image
  7. Behind the Jura sign are two screws with an oval head. They have to be removed.
  8. These screws have an oval head that makes them look like rivets (picture 2). You need to use a special bit for their removal. If the right bit is not available, it could be done with a pair of needle nose pliers. Jura wants to keep us out of our own machines!!!!
    9. Step image Step image
  9. Push the back down a bit and then remove it.
    10. Step image Step image
  10. Pull the right side panel- as seen looking to the frontpanel - backwards and take it off.
  11. Sometimes it gets a bit stuck and may require a bit more of a pull.
    12. Step image
  12. In this step, you should remove the screws of the left side panel. The side panel can only be removed after removing the top cover.
  13. Remove the Torx T15 screw on the front wall of the side panel.
  14. In the side part there is a lid over the brew group. The lid is fastened at the top with two oval head screws. Remove those to remove the lid.
  15. With the cover removed the brew group becomes visible
    16. Step image Step image Step image
  16. This step shows how to remove the top cover
  17. Remove the powder tray and all coffee beans.
  18. The cover is fastened with three Torx T15 screws. Those are easily visible under the covers as well as the small cover on the left back side.
  19. Remove the two Phillips screws on the bean container and remove the bean container.
  20. Lift the cover upwards.
  21. If it is stuck, use a plastic opening tool to carefully pry it open.
  22. The lid of the bean container is held in place by a small, strong magnet that loosely rests. It is either in the green marked recess, or it remains hanging on the bean container. Make sure it is not lost!
    23. Step image Step image Step image
  23. Pull the left side panel backwards to take it off.
  24. For some repairs it is not necessary to remove the left side panel.
    25. Step image Step image
Back