Clamp Press

ID: 124998

Description:

Steps:

  1. Clean the Faces
  2. Place the tang against the bottom of the hammer
  3. Without applying pressure to the die, tighten the upper screws of the mold holder
  4. Apply light pressure with the hammer on top of the mold base and secure the bottom part of the mold base
  5. Clean the upper and lower base of the shock plate
  6. Release the pressure from the springs and set to zero
  7. Place the die and adjust it until it hits the stop using the front screws
  8. Tighten the die splints
  9. Attach the punch and the extraction ruler
  10. Clean the mold carrier and cutting carriage faces
  11. Measure the blade height on the cutting carriage
  12. Note: Lower blade on the plane of the cutting carriage
  13. Note: Assemble the upper blade 0.1 mm lower than the stops
  14. Place the cutting carriage in the mold holder
  15. Raise the hammer using the screw
  16. Insert spacer shims according to the size of the clamp to be made
  17. Press the cutting carriage and separators against the die
  18. Secure the bottom of the car to the mold carrier base
  19. Attach the upper part to the top of the mold holder
  20. Insert the corresponding size guide and feed the band through
  21. Lower the hammer using the screw until it touches the stops and cuts the band
  22. If it does not cut, shim the upper blade
  23. Verify again that the lower blade is flush with the cutting carriage using the caliper as a straightedge
  24. Perform the bend and check the punch height
Back