HP ElitePad 1000 G2 Battery Replacement

ID: 125113

Description: If your HP ElitePad 1000 G2 won’t turn on and...

Steps:

  1. Before disassembling the tablet: make sure the tablet is off, disconnect the power cord from the tablet, and disconnect all external devices from the tablet.
  2. Using a Phillips #00 screwdriver, remove the two Phillips PM 1.4×3.2mm screws located next to the charging port.
    3. Step image Step image Step image
  3. Place the suction cup on the lower right corner of the tablet display glass, making sure to place the suction cup inside the edges of the border of the display glass.
  4. Insert a plastic pick in between the display and the tablet case. Then use a plastic removal tool to separate the display further.
  5. Pull on the suction cup while using the prying tool to separate the display from the tablet.
  6. Gently lift the display from the tablet in order to avoid damaging the cables.
    7. Step image Step image Step image
  7. To disconnect the cables, use the spudger tool to gently pull back on the black tab located on the side of the connector while gently pulling the cable.
  8. Release the zero insertion force (ZIF) connector to which the TouchScreen cable is attached, and then disconnect the TouchScreen cable from the system board.
    9. Step image Step image Step image
  9. Release the ZIF connector to which the display cable is attached, and then disconnect the display cable from the system board.
    10. Step image Step image
  10. Remove the display from the tablet.
    11. Step image Step image
  11. Locate the NFC antenna.
  12. Release the ZIF connector to which the NFC antenna cable is attached.
  13. To disconnect the cable, use the plastic prying tool to gently push on the tab located on the side of the connector.
    14. Step image Step image
  14. Detach the NFC antenna from the surface of the system board.
  15. The NFC antenna is attached to the system board with double-sided adhesive.
  16. Remove the NFC antenna.
    17. Step image Step image
  17. Locate the power button board ribbon cable.
  18. Locate the battery to motherboard connector.
    19. Step image
  19. Lift the clear tape attached to the power button board ribbon cable.
  20. Disconnect the ZIF connector by using a plastic removal tool to gently pull up on the black tab.
  21. Lift the power button board ribbon cable up and away so that it doesn't get in the way of the battery during removal.
    22. Step image Step image Step image
  22. Disconnect the battery to system board connector by pushing gently on it with a plastic pry tool and then pull it away from the system board.
    23. Step image Step image
  23. Using a philips 00 screw driver take out the six Phillips PM1.3×2.0mm screws
    24. Step image
  24. Carefully lift the battery away from the bottom cover.
    25. Step image Step image
Back