Quiksilver The Fifty50 Circuit Board Replacement

ID: 125537

Description: This replacement guide will teach someone how...

Steps:

1. Place the watch (face down) on a solid surface.
2. Carefully use the screwdriver and push in one side of the strap.
3. Slowly remove the strap by pushing back one of the hidden metallic holders for the strap.
4. If you are having difficulty trying to take off the strap, feel free to use a 3.5 flat head screw driver, or any kind of tool that make this step easier.

5. Gently pull the pin out of the strap.
6. Carefully handle the small metallic holder, as they are sharp and may be difficult to locate if lost.

7. Remove the four 1.1 mm screws holding the back panel in place using the Phillips #00 screwdriver.

8. Carefully separate the panel off of the watch.
9. Careful not to lose the four 1.1 mm screw or else the back panel will not be able to put back.

10. Carefully lift the white plastic circular out of the watch.

11. Remove the four 1.1 mm screws located on the metallic holder using the Phillips #00 screwdriver.

12. Remove the large circular Analog battery.

13. Using the Phillips #00 screwdriver, remove the two 1 mm screws holding the circuit board to the device.

14. Remove the green circular chip using a pair of tweezers.