MiTM Pressure Washers CA2703HDHB1 2017 Output Assembly Replacement

ID: 127583

Description: This is a prerequisite guide only! This is not...

Steps:

1. There are two versions of the unloader assembly:
2. First image—earlier pressure washers feature an all-in-one assembly (part 8-0631) that’s easy to replace, but gave users the ability to break the pump.
3. Second image—later models use a tamper-proof, harder to remove unloader (part 8-0656), connected by a series of pipe fittings.
4. This guide is written for the tamper-proof unloader assembly.
5. If you need to remove an all-in-one style unloader, use a large adjustable wrench to unscrew the two large Banjo bolts. This will disconnect the unloader from the pump assembly.

6. Before you begin, be sure that the engine is powered off and is cool to the touch.
7. Grab the plastic housing at the end of the spark plug wire.
8. Pull firmly to disconnect the wire from the spark plug.

9. Use a 1/4" socket or a large flathead screwdriver to loosen the hose clamp near the inlet filter.
10. Slide the hose clamp away from the end of the hose.

11. Wiggle the hose and pull it off of the brass nipple.

12. Slide a 3" tall block underneath the pump assembly to help support the pump.

13. Use a 1/2" or adjustable wrench to loosen and twist the return elbow half a turn, so that it faces the opposite direction.
14. This will allow the fitting to clear the pump edge without being removed.

15. Use a large adjustable wrench to loosen and unscrew the filter.

16. Remove the filter with the return elbow attached.

17. Use a 1" or large adjustable wrench to loosen and unscrew the pump input elbow.

18. Remove the input elbow fitting.

19. Use a 3/4" or adjustable wrench to loosen and disconnect the coupling from the pump assembly.

20. Remove the output assembly.