Hover 1 Eclipse Bluetooth Speaker Replacement

ID: 127646

Description: This guide will teach you how to replace the...

Steps:

  1. Using a Phillips #1 Screwdriver, remove the four 11mm screws that surround the edge of the plug side bottom shell piece.
  2. Using a Phillips #1 Screwdriver, remove the four 13mm screws that surround the edge of the plug side bottom shell piece.
  3. Remove the plug side bottom shell piece
    4. Step image Step image Step image
  4. within the plug side shell piece, there are two white and pink wires connecting the shell and the motherboard.
  5. On the circuit board by the speaker, carefully squeeze and unplug the small white headers that connect the shell piece to the hoverboard body.
  6. On the body of the board, follow the wires that connect the lights to the motherboard. Disconnect these wires from the motherboard by squeezing and pulling the small white headers.
  7. Now you can fully remove the shell piece.
    8. Step image Step image Step image
  8. Using a Phillips #0 Screwdriver, remove the 3 screws holding the speaker to the shell.
  9. Lift the speaker out from the casing.
    10. Step image Step image Step image
Back