Xbox One S All Digital Edition IR Blaster Replacement

ID: 127652

Description: This replacement guide provides a step by step...

Steps:

1. Position the iFixit Opening Tool's riveted edge in between the top and bottom cover of the plastic enclosure.
2. Apply downward pressure on the iFixit Opening Tool until the security clip unlocks.
3. Repeat on different points of the plastic enclosure until the bottom cover is removed.

4. Remove the six 50 mm green screws (labeled F1-F6) from the metal chassis using a Torx 10 screwdriver.
5. These screws hold the top cover of the plastic enclosure to the chassis.

6. Apply pressure to peel off the sides of the casing.
7. Separate the metal chassis from the top cover, lifting the back of the chassis up and away from the top cover.
8. The plastic back panel is meant to stay attached to the metal chassis.

9. Flip the metal enclosure so that the fan cover is on top.

10. Remove the four 15mm screws attaching the IR Blaster to the metal chassis with the Torx T8 Security screwdriver.

11. Carefully remove the IR Blaster from the metal chassis.
12. The connector is very fragile. Make sure you pull the board away from the case and not sideways.