Hover-1 Charger Gyroscope Sensor Board Replacement

ID: 127797

Description: If you are having trouble balancing on your...

Steps:

1. Flip the hoverboard over so that the warning label is facing up.
2. Remove the twelve 12 mm screws with a Phillips #2 screwdriver.
3. Remove the four 10 mm screws with a Phillips #2 screwdriver.
4. The screws nearest to the wheels may be hard to access. Be sure to use a long, thin screwdriver.

5. Pull the right cover away from the hoverboard to expose the battery.

6. Disconnect the two pronged black and yellow cable.

7. Pull the left cover away from the hoverboard.

8. Disconnect the two pronged black and yellow cable. The battery is now fully disconnected.

9. Unplug the white five pin connector from the gyroscope sensor board.
10. Unplug the red, yellow, blue, green, black and white six pin connector.
11. Unplug the black and red two pin connector.
12. Unplug the black, yellow, green and red four pin connector. Unplugging this connector is photographed as an example.

13. Remove the four 10 mm screws from the gyroscope sensor board with a Phillips #2 screwdriver.

14. Push the rubber sheaths away from the clasp of the green bullet connector.
15. Grasp the connector at the metal junction and disconnect.
16. Repeat for the yellow and red bullet connectors.
17. There may be a zip tie holding these wires together. Cut this off.
18. These bullet connectors may be hard to disconnect; do not be afraid to pull with strong force.

19. Remove the gyroscope sensor board.