Swann Wi-Fi Indoor Security Camera Motion Sensor Replacement

ID: 127811

Description: This repair guide will provide steps to replace...

Steps:

1. Use the Phillips #0 to remove the screw located on the back of the camera above the mount.
2. Slide the mount out from the bottom of the device.

3. Remove the back of the case by placing a iFixit opening tool underneath the edge of the case and prying it up.

4. Carefully remove the back of the case without pulling the cables connected to the motherboard and the speaker on the back of the case.

5. Facing the inside of the front of the case, release the white ribbon cable by pulling the black rectangular connector at the end of the connection
6. Once the black holder is opened, gently pull the cable out of the holder.

7. Facing the back of the small board, remove the two 2.0 mm Phillips #0 black screws that connect it to the back of the case.

8. Carefully use a soldering iron to melt the solder in three places that connect the motion sensor. For more information on soldering follow this helpful guide.
9. Pull the sensor out from the motherboard.