Toshiba Satellite C875-S7304 RAM Replacement

ID: 127842

Description: Use this guide to upgrade RAM or to replace...

Steps:

1. Power off and unplug the charger from your device.
2. Carefully flip your device upside down laying it onto a flat surface with the battery facing you.
3. The two eject switches are located on the right and left side of the battery compartment.

4. Slide the right switch further towards the right to lock it into place.

5. Slide the switch to the left. Continue to push the switch because unlike the right switch, it will not lock into place.

6. Using both hands, continue to push the left switch and grasp onto the center notch located in between the right and left switch.
7. Pull the center notch towards you and you will notice the battery will start to eject.

8. Lift the battery out carefully using two hands.

9. Use a Phillips #1 to unscrew one 7.0 mm screw from the hard drive/RAM panel.
10. You cannot remove the screw from the panel. Simply unscrew it until loosened.

11. Wedge the plastic opening tool between the back panel and the hard drive/RAM panel near the screw.
12. Lift the end of the opening tool slowly until the hard drive/RAM panel separates on one side.
13. Repeat the steps above on the left side of the hard drive/RAM panel.
14. Pull the cover towards you and up from the device to remove it.
15. Hearing a popping noise while wedging the plastic opening tool is normal.

16. Push outward on the metal tabs to unclasp the RAM from its slot.
17. With the RAM unclasped at a slight angle, carefully pull it out with two hands.
18. When reassembling, remember to align the indentation on the RAM with the indentation on its slot.