DigiLand DL718M Screen Replacement

ID: 127946

Description: If your Digiland DL718M tablet has a damaged or...

Steps:

1. Remove back panel by wedging the iFixit opening tool on all four sides of the device.

2. Remove two silver Phillips #0 screws along the bottom of the internal panel.

3. Remove the ribbon in the bottom left corner of the motherboard by lifting the black tab and sliding the ribbon out from the slot underneath the black tab.

4. Remove the small, circular microphone on the left side of the device by sliding it out of its slot using an opening tool.

5. Remove the front-facing camera in the top left corner of the device by sliding it out of its slot using an opening tool.

6. Remove the three black Phillips #0 screws along the left side of the motherboard.

7. Detach the black tape and the wire from the right side of the screen.

8. Remove the rear-facing camera by prying it off of the back side of the screen using the an opening tool.

9. Lift the motherboard and remove it from the device using an opening tool.
10. If there is any tape on the device that prohibits you from doing so, remove the tape.

11. Remove the ribbon above the battery by lifting the black tab and sliding the ribbon out from the slot underneath the black tab using an opening tool.

12. Pry the battery off of the back of the screen by wedging the iFixit opening tool underneath.

13. Lift the screen from the plastic casing.