Koss Porta Pro Speaker Holder Replacement

ID: 130207

Description:

Steps:

1. Remove cushion using knife.

2. Remove label using flat screwdriver.

3. Use screwdriver to start bending edges of clip.
4. Continue bending with pliers or cutters.
5. Push clip with screwdriver and pull with cutters from another side.
6. This step can take up to 15 minutes, so keep calm and continue bending.

7. Press tenon using screwdriver to remove shield.
8. Remove hoop from hoop holder.

9. Place hoop in hoop holer.
10. Close hoop holder with shield.
11. Insert M2.5x8 screw into hole and tighten the nut.

12. Stick comfortZone label over the screw. Use double-sided foam tape if head of screw is too high.
13. Stick cushion. Use additional double-sided tape if cushion has bad holding.