HP Z2 Mini G3 CPU Fan Replacement

ID: 130404

Description: The CPU fan supports the HP Z2 Mini G3 (Model...

Steps:

  1. Turn the device so the back-side of the device is facing you.
  2. Be sure that the power is off and the A/C power cord has been disconnected before starting. Removing hardware while the power is on could damage the device or harm yourself.
  3. Components of the device are subject to static damage. Work on a hard, grounded surface to prevent damage to the workstation.
    4. Step image
  4. Slide and hold the latch in the direction of the engraved arrow (to the right).
    5. Step image Step image
  5. While holding the latch, lift the access panel upwards and towards yourself and set it aside upside-down.
    6. Step image Step image
  6. Rotate the device so the front side is facing you (the side with the power button) and locate the CPU fan.
    7. Step image
  7. Swing the fan upward, to a 90-degree angle.
    8. Step image
  8. Carefully disconnect the CPU fan by pulling out the wires from the motherboard.
    9. Step image Step image
  9. Swing the fan back down and carefully unhook the CPU fan notches by pulling each tab away from the heat sink holes.
    10. Step image
  10. Swing the fan up again and pull it out.
    11. Step image
Back