iRobot Braava 380t Teardown

ID: 132432

Description:

Steps:

  1. Flip over the Braava
  2. Remove the 4 screws circled in red in the photo.
    3. Step image
  3. Flip over the Bravva
  4. Raise the cover, which should offer no resistance.
  5. Disconnect the red and black wire plug.
  6. Remove the cover.
    7. Step image
  7. The robot is now open. Take the opportunity to clean the contactors on the front.
    8. Step image
  8. To continue dismantling and gaining access to the motors, remove the stickers.
    9. Step image
  9. The screws of the engine covers are then clearly visible.
    10. Step image
  10. Remove the covers.
  11. Do not try to pull the engine out at this time!
    12. Step image
  12. Remove the wheel cover by turning it a few degrees.
    13. Step image
  13. Remove the circlip using special pliers (cut here to be small enough)
  14. Take out the wheels, and remove all the stuck hair and dirt.
    15. Step image Step image
  15. Undo the 2 screws. Next, remove the wheel guard.
    16. Step image
  16. You can then take out the motor and possibly dismantle the gearbox. But it's no use, as I didn't find any hair inside.
    17. Step image Step image
Back