Logitech VX Nano Wireless Mouse Opening Procedure

ID: 132678

Description: Prerequisite only guide to open the Logitech VX...

Steps:

1. Pull down on the battery release tab to remove the battery cover.
2. Remove battery cover.

3. Pull the battery release tab away from the mouse so the two AA batteries come out.

4. If the Nano Receiver is still in the mouse and not in your computer, remove it by pushing on the bright orange button. It should pop right out!

5. Find and remove the screws at the bottom of the battery compartment:
6. Two 6 mm Phillips #1 screws
7. When removing these two screws, it can be helpful to hold the plastic battery tab out of the way of your screwdriver.

8. Use an opening pick to get underneath the corner of one of the adhesive skates.
9. As you start to remove the skate, make sure that the opening pick is underneath the entire adhesive pad—otherwise you run the risk of splitting the pad in half.
10. Continue to push the opening pick between the adhesive and the mouse case, slowly working the adhesive away from the case.
11. Repeat this same process for the two other skates.
12. Remove any old adhesive residue before applying new mouse skates.

13. Remove the screws from the backside of the mouse:
14. Three 6 mm Phillips #1 screws
15. The top shell and bottom case are no longer connected. Keep the mouse steady so you can carefully remove the upper shell in the next step.

16. Carefully separate the top plastic shell from the bottom case.
17. Remove the top shell.