HP Envy m6-k015dx Screen Replacement

ID: 132689

Description:

Steps:

  1. Shut down the computer
  2. Remove all external devices
  3. Unplug the AC adapter
  4. Close the computer
  5. Turn it upside down
  6. Remove the 12 screws from the bottom.
  7. Gently remove the service cover
  8. Disconnect the battery cable from the motherboard.
  9. Remove the 4 screws that hold the battery.
  10. Gently lift the battery out of the computer.
  11. Remove the fan cable
  12. Remove the 2 screws around the fan
  13. Lift the fan up
  14. Unscrew the 3 screws that hold the card reader board to the system
  15. Raise the card reader board from the system
  16. Remove the four screws that pin down the hard drive
  17. Disconnect the harddrive from its connector
  18. Remove the harddrive
  19. Only complete this step if your computer model has a solid state drive
  20. Remove the two screws at the top of the solid state drive
  21. Remove the solid state drive
  22. Remove the thirteen screws around the keyboard bracket
  23. Gently remove the keyboard bracket from its top
  24. Remove the 4 screws on the touchpad's board
  25. Gently lift the touchpad board from the side that the screws were on
  26. Remove the touchpad board
  27. Unscrew the four screws around the hinges
  28. Pull the hinges upward
  29. Lift the keyboard section of the computer up
  30. Slide out the display
  31. Remove the plastic bezel cover
  32. Remove the ten screws holding the hinge to the display
  33. Remove the four screws arouund the display
  34. Remove the adhesive strip out of the true display
  35. Disconnect the display's cable
  36. Remove the display
Back