Wacker Compactor Plate VP1550AW 2014 V-Belt Replacement

ID: 133064

Description: Follow this guide to remove the drive belt for...

Steps:

  1. Before you begin, be sure that the engine is powered off and is cool to the touch.
  2. Grab the plastic housing at the end of the spark plug wire.
  3. Pull firmly to disconnect the wire from the spark plug.
    4. Step image Step image
  4. Use a 1/2" socket and wrench to loosen the two bolts securing the belt guard.
  5. The bolts are captive and should not be removed.
    6. Step image
  6. Remove the belt guard.
    7. Step image Step image
  7. Use scissors or a blade to cut the drive belt.
  8. Remove the drive belt.
    9. Step image Step image Step image
  9. Loop the replacement belt onto the small pulley.
    10. Step image
  10. Replacing the belt poses a substantial pinching hazard. Wear safety gloves and be mindful where you position your fingers.
  11. Guide the belt over the top of the clutch pulley.
  12. Loop the belt underneath the pulley axle.
  13. Rotate the pulley slowly and guide the built into the groove.
  14. Getting the replacement belt back onto the drive pulley requires considerable strength.
    15. Step image Step image Step image
Back