2 slice Dualit toaster Disassembly

ID: 133074

Description: This guide is designed to assist in the service...

Steps:

  1. 4 x rubber feet
  2. 5 x metal screws
  3. Remove the rubber feet and screws with a phillips head screw driver.
    4. Step image
  4. 1 x Matte Aluminium Bottom Plate
  5. After removing the Feet and Screws the Bottom plate simply lifts off.
    6. Step image
  6. simply slide out the aluminium crumb tray
    7. Step image
  7. 1 x Stainless Steel main casing
  8. 6 x Phillips Head Metal Screws
  9. Remove screws from main body of toaster and ply the metal casing off with your hands from either side.
    10. Step image
  10. 1 x Casted Aluminium End Cap from the left hand side of the toaster
  11. After removing the screws from part 4 this end cap will just pull off with a gentle tug.
    12. Step image
  12. 1 x Cast Aluminium timer casing
  13. To remove the other side casing of the toaster you must first disconnect the electrical cords from the elements
  14. Once all the cords are unplugged the casing will simply pull off the same way as the other side casing was removed
    15. Step image
  15. 2 x Nut
  16. 2 x Bolt
  17. 2 x Washers
  18. 1 x Galvanised Steel elements fastener plate
  19. To remove the element fastener plate us the pliers to prevent the nut from twisting whilst unscrewing the bolt with the PH screwdriver.
  20. Once unscrewed the plate should easily pull away.
    21. Step image
  21. 1 x Lever mechanism
  22. 1 x Spring
  23. 1 x Washer
  24. 1 x Plastic lever handle
  25. 2 x Aluminium fastening plates
  26. To remove the Lever mechanism you must first unscrew and remove the black plastic handle.
  27. After this the two fastening plate will can be removed. The screws holding these in place have already been removed in the previous step.
  28. The lever mechanism can now be removed from the toaster. This may take some manoeuvring for the mechanism to slide out.
    29. Step image
  29. 3 x heating elements
  30. 2 x Brass dividers
  31. 2 x Copper wires
  32. 2 x Bolts
  33. 6 x Washers
  34. 4 x Nuts
  35. To remove the heating elements unscrew the bolts with the PH screwdriver whilst holding the nuts with the pliers
  36. Once unscrewed the wires and copper dividers are able to be removed. Then simple slide out the heating elements. The elements need to be replaced in the same slots they came from so label them.
    37. Step image
  37. 2x aluminium internal side panels.
  38. These thin aluminium plates will then be removed from the main body assembly. These sheets help reduce heat admitted from the toaster upon use.
    39. Step image
  39. 3x bent stainless steel excursions.
  40. These parts are holding the bread in a perfect position in relation to the elements. They are then to be popped out of place from the main body assembly.
    41. Step image
  41. This is the final sub assemble or main body you are left with. This body is the queen bee of all the above parts.
    42. Step image
Back