Huawei Watch 2 Battery Disconnect

ID: 135688

Description: prereq only Huawei Watch 2 Battery Disconnect

Steps:

1. Before starting repairs, take your watch off the charger and power it down.
2. Feel free to attach or remove the watch band as needed to provide more control as you make repairs.

3. Remove the four Torx T2 screws (4.5 mm length).

4. Use a pair of tweezers to remove the four plastic covers sitting next to the watch band holders.

5. Insert an opening tool into the gap between the back cover and the watch case at the bottom edge of the back cover.
6. Use the opening tool to pry up the back cover of the Huawei Watch 2.
7. Do not remove the back cover assembly all the way yet—it's still connected to the mainboard.

8. Carefully fold the back cover assembly to the opposite side of the two watch crowns.

9. Remove the Phillips #00 screw (1.8 mm length).

10. The heart rate sensor flex cable is attached to the metal shield which covers the battery connector. In order to avoid damage to the flex cable, only grab the metal shield on the bottom end where the Phillips screw was located.
11. Use a pair of tweezers to carefully remove the metal shield.
12. Remove the back cover assembly.

13. Use the flat end of a spudger to pry up and disconnect the battery flex cable.