How to use the 2010-2017 Suzuki Swift emergency jack

ID: 135823

Description: The included emergency jack should only be used...

Steps:

1. Open the boot, turn over the floor and retrieve the jack crank and the socket wrench.
2. Open the compartment where the jack is located.
3. Using the jack crank, turn the jack axle counter clockwise to unsecure it from the compartment and pull it out.

4. There are 4 u-shaped jack supports underneath the car, located next to each wheel.
5. Turn the jack axle by hand until the support slot of the jack can be placed on the support.
6. Only use the emergency jack on the jack supports.
7. Make sure the car is on a hard level surface.
8. Make sure the jack has at least 51mm load free displacement from its starting position.

9. Make sure the handbrake is on, and the gear is in reverse for manual or park for an automatic transmission car.
10. Make sure no people are in the car when the car is jacked up.
11. Place the jack crank on the jack axle, and using the socket wrench, turn clockwise.
12. Stop cranking when the wheel is high enough from the ground to be replaced.
13. Do not go underneath the car while it is jacked up with the emergency jack.