Removal of the Saeco Exprelia top cover

ID: 136112

Description: Basic instructions: Removing the upper part of...

Steps:

1. Remove all accessory parts like the water reservoir, the brewing assembly as well as the drip try.
2. Remove all coffee beans from the bean container
3. Always remove the power cord
4. Remove the two T10 Torx screws from the bottom of the rear cover.

5. Pull the back cover approximately 1 cm (3/8inch) out from the bottom and push it in an upward direction.

6. Remove the five T10 Torx screws as marked
7. the back frame consist of 3 pieces. Lift the top part out first, then each one of the side pieces

8. Lift the bean compartment lid and loosen the Torx T10 screw.
9. Open the water compartment lid and loosen the Torx T10 screw.
10. The lid is locked into place several times. Carefully loosen the catches and lift off the lid.
11. Note: If you only want to remove the left cover on the water compartment, all you need to do is loosen the cover a little and lift it up by about 2 cm.