Creality Ender 3 Pro and V2 32 Bit BL Touch Install Replacement

ID: 139258

Description:

Steps:

1. Attach the probe to mount with provided M3x 6 screws, positioning the probe with the connection towards the nozzle.
2. Plug in the connection like shown.
3. Final mounting should look like this.
4. Use provided cable ties and attach harness in 3 places. Do not over tighten the cable ties.
5. The probe mounting is a different between the Ender 3 V2 and Ender 3 / Pro but the bulk of this guide applies to all the 32 bit Ender 3 Variants.

6. See our Detailed Wiring Diagram
7. The original Z limit switch connection will not be used. Leave unplugged.
8. Use a provided cable tie to attach the BL Touch wires to the rest of the wiring bundle.
9. Assemble the green connector. Wiring must match through the connection but wiring order is not important to start. To be safe, assemble like in the picture.
10. Reinstall the bottom cover, making sure to plug your fan back in.

11. Double check wiring before plugging the green connectors in or powering on the machine! If you mixup wiring, damage can occur.
12. Firmware is different for the Ender 3 / Pro , Ender 3 V2. Please contact us with your board type and machine for firmware and screen files.

13. Insert wisdom here.

14. Insert wisdom here.

15. Insert wisdom here.

16. Insert wisdom here.

17. Insert wisdom here.

18. Insert wisdom here.