Barreto Tillers E1320HTRLR 2016 Tine Replacement

ID: 140130

Description: This guide shows how to remove and replace the...

Steps:

1. Before you begin, ensure that the engine is powered down and cool to the touch.
2. Grab the plastic housing at the end of the spark plug wire and pull firmly to disconnect it.

3. Flip the red engine ON/OFF switch to the OFF position.

4. Flip the fuel valve lever to the OFF position.

5. Flip the ignition switch to the OFF position.
6. Ensure the wheel drive control lever is set to the neutral position.

7. Pull the locking pin out and rotate it 90˚ to unlock the right wheel from the hub.
8. Repeat for the left wheel.

9. Insert wheel chocks underneath each wheel to keep the device stationary during disassembly.

10. Use a 5/8 inch socket with an 11/16 inch wrench to loosen the two 5/8 inch bolts and two 11/16 inch nuts securing the tine to the tine shaft.
11. Remove the two tine nuts.

12. Remove the two bolts holding the tine to the tine shaft.
13. During reassembly, use Loctite 271 on tine bolt threads to prevent them from loosening.

14. Remove the tine.
15. Repeat this procedure for each tine you need to replace.
16. Keep track of each tine's orientation.