Barreto Tillers E1320HTRLR 2016 Tine Shaft Replacement

ID: 140141

Description: Prerequisite only! This guide shows how to...

Steps:

1. Before you begin, ensure that the engine is powered down and cool to the touch.
2. Grab the plastic housing at the end of the spark plug wire and pull firmly to disconnect it.

3. Flip the red engine ON/OFF switch to the OFF position.

4. Flip the fuel valve lever to the OFF position.

5. Flip the ignition switch to the OFF position.
6. Ensure the wheel drive control lever is set to the neutral position.

7. Pull the locking pin out and rotate it 90˚ to unlock the right wheel from the hub.
8. Repeat for the left wheel.

9. Insert wheel chocks underneath each wheel to keep the device stationary during disassembly.

10. Use an 8 mm socket to remove the outboard bearing grease fitting.

11. Use a 9/16 inch socket to remove the four bolts securing the tine shaft to the side plate.
12. Use a 9/16 socket and wrench to remove the five bolts and accompanying nuts securing the side plate to the frame, three on the outside and two in the wheel well.

13. Tilt the tiller up so the motor side is resting on the work surface with the tines raised.

14. Use a 1/2 inch socket and wrench to remove the four bolts and accompanying nuts securing the side plate to the tine cover.

15. Slide the side plate down and away from the device to remove it.

16. The tines closest to the tine drive motor need to be removed in order to allow access to the bolts securing the tine shaft to the hub.
17. Use a 5/8 inch socket with an 11/16 inch wrench to loosen the two 5/8 inch bolts and two 11/16 inch nuts securing the tine to the tine shaft.
18. Remove the two tine nuts.

19. Remove the two bolts holding the tine to the tine shaft.

20. Remove the tine.
21. Repeat this procedure for all four tines closest to the tine drive motor, opposite the outboard bearing assembly.
22. Keep track of each tine's orientation.

23. Use a 5/8 inch socket with an 11/16 inch wrench to remove the two 5/8 inch bolts and two 11/16 inch nuts behind each removed tine.
24. Repeat this for each of the four tine locations; there are a total of eight bolts to remove.

25. Remove the tine shaft from the hub.