Wacker Pump PG1 2014 Impeller Replacement

ID: 141880

Description: Use this guide to remove or replace the...

Steps:

1. Before beginning repairs, disconnect and remove all hoses.
2. Flip the motor ignition switch into the OFF position.

3. Use a 13 mm socket to remove the two bolts securing the handle.

4. Remove the handle.

5. Use a 13 mm socket to remove the two bolts securing the float chamber housing.

6. Remove the float chamber housing.

7. Use a 4 mm hex key to remove the bolt securing the engine cover.

8. Lift up to remove the engine cover.

9. The impeller is threaded onto the motor's output shaft and will need to be loosened. In order to stop the shaft from rotating, the motor fan assembly will need to be blocked.
10. Insert a flathead screwdriver between two fan blades on the motor fan assembly.

11. Tap the impeller on one of its blades with a rubber mallet and a punch to break it loose from the threads on the output shaft.

12. Use your fingers to unthread and remove the impeller.
13. With the impeller removed, the seal kit spring will become loose and may fall out.