Backbone One Left Bumper Replacement

ID: 142440

Description: Use this guide to replace the left bumper in...

Steps:

1. Use a Phillips screwdriver to remove the four 5.9 mm-long screws.

2. Lift up the upper part of the controller.
3. Swing over the upper cover and place it on the controller case.
4. Take care that the interconnecting cable has no tension.

5. Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector.

6. Use the tip of an opening pick to open the gray flap of the ZIF connector by pushing it upwards.

7. Use your fingers to disconnect the interconnect cable from its connector.

8. Remove the upper half of the left controller assembly.

9. Use a Phillips screwdriver to remove the 5.9 mm-long screw which is securing the trigger.
10. The screw is difficult to reach. Insert the screwdriver at an angle of 45 degrees.

11. Remove the left trigger.

12. Use your fingers to remove the left bumper.