Ledlenser Stirnlampe H8R torn cable

ID: 147659

Description: The cable on the Ledlenser H8R headlamp was tor...

Steps:

  1. turn and pull the silver focus ring and the lamp will open up
    2. Step image
  2. Unscrew 2 screws, you need a Torx T6 for this
  3. then remove the white part
  4. do not touch the LED!
    5. Step image
  5. Remove residue from the torn cable
  6. Remove the cable ties
    7. Step image
  7. Riddle: which wire goes where?
  8. red = D+ / black = D-
  9. green = VSS / yellow = SW (= switch)
  10. white = NTC (= temperature sensor)
    11. Step image
  11. To be on the safe side, remove the battery from the battery compartment
  12. Attention, before soldering don't forget:
  13. Thread the cable through the two housings
  14. Thread the cable through the kink protection
    15. Step image
  15. Solder 5 times
  16. Secure cable with cable tie
  17. Now you can test, but please only briefly, otherwise the LED will get too hot
  18. Assemble the lamp!
    19. Step image
Back