Yobo Gameware Controller Trigger Spring Replacement

ID: 149118

Description: This guide will provide a step by step process...

Steps:

  1. Be sure the controller is disconnected from the console or any source of power.
  2. Place the controller (button - side down) on a clean, solid work surface.
  3. Use your screwdriver to remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.
    4. Step image Step image
  4. Gently life the back panel up, separating it from the front panel.
  5. Some components could fall off the front panel if the controller is knocked around during this step.
    6. Step image Step image
  6. Depress the trigger assembly using your index finger while using your thumb to keep upward pressure on the grey square bracket and clear circular component on the underside of the trigger assembly.
  7. Maintain a firm grip on the entire assembly, as the components could spring apart if you release pressure.
  8. Rotate the assembly upwards and towards you to remove it from its housing in the controller.
  9. The removal process is the same for both the left and right triggers.
    10. Step image Step image Step image
  10. Gently release pressure on the trigger assembly, allowing the components to come apart on your work surface.
  11. A new spring may now be incorporated into the designated trigger assembly.
    12. Step image Step image
Back